The General scarifier assembly for use on single and dual head floor grinders has Alloy-X™ hardened steel flails for a fine finish or for breaking up hardened deposits of foreign matter on concrete floors. Please note that they are NOT a surface planer and will NOT mill down hard concrete surfaces. They will however roughen the cap to create a slip resistant surface.

General Equipment Model SG24-1610

• Not recommended for soft or "gummy" deposits
• Removes thin-set coatings and urethanes
• Texturing slippery floors for a slip resistant surface
• Initial grinding of rough, broom-finished concrete
• Preparing surfaces for overlayments
• Breaking up hard-surfaced deposits of fiberglass rubber grout or plaster
• Size: 2 inch x 2 inch x 4 inch

Attachments Available See Realated Products Below

Scrape-R-Tach carbide floor coatings removal system.

Scarifiers roughen concrete floors or remove hardened brittle deposits on floors.

Grinding Stones

Diam-A-Tach diamond concrete floor ginding system