Trim Cutter uses a unique 4 point track bearing system to ensure tool doesn't ride off the brake during cut. Low profile grip area allows you to direct power along the plane of the cut resulting in one smooth motion that leaves factory edges every time.

Designed to make your job site life a little easier while saving you time and money, you can count on TrimCutter to handle your material cutting needs. As with all our products, we are confident this tool will become an integral part of your job routine. By the time you add up the savings in time and labor, you'll realize what thousands of contractors already know, TrimCutter pays for itself in no time at all.

Van Mark Model No. 3017

• Knives made from 100% hardened tool steel
• Tool uses 4-point roll bearing track system
• Use with Mark I , II, IV and Metal Master 20 Series Brakes.

Cutting Capacities

Up to .063 Aluminum

Up to 32 oz. Copper

Up to 20 ga. Galvanized Steel

Up to All Vinyl, Sheet and Coil

Up to 24 oz. Zink

Up 24 ga. Stainless Steel(half-hard)